Home > Glorious Mice > Wired Mice > Model D/D Minus > Ascended Cable Replacement Guide (Model O, O-, D & D-)

Ascended Cable Replacement Guide (Model O, O-, D & D-)

Tools Needed

How to Replace Your Mouse's Ascended Cord

1. Remove bottom two G-Skates under the logo with a flat head screwdriver.

2. Unscrew the housing using a Philips head screwdriver.

3. Detach the housing by pulling back on the housing towards the scroll wheel then pull up gently. Be aware of the black strips that are attached to the circuit board. Do not remove these.

4. Unplug the old cable by pulling on the white plug gently. Remove the wiring from the base of the mouse. Then remove the SR Cable under the scroll wheel.

5. Grab your new Ascended Cord and plug in the white plug into the board of the mouse. Make sure to use the right side of the plug.

6. Route the wiring between the two pegs on the base of the mouse and place the SR Cable of your new Ascended Cord in its designated housing in front of the scroll wheel. Make sure that there is ample room in front of that scroll wheel.

7. Place the housing back on and screw them in place.

8. Wipe clean the G-Skate housing area.

9. Peel the G-Skate adhesive and place them accordingly into the G-Skate border area. Press firmly for a few seconds to secure the G-Skate onto your mouse.

Your warranty will NOT be voided if you follow the instructions and open your Glorious mouse for the purpose of replacing its cable.